This unique plug-on transmitter design will ideally match any microphone or line level source via a standard XLR connector. Phantom power is selectable at 5, 15 and 48 volts, or can be turned off for use with dynamic microphones and line level signal sources.

The design includes a wide tuning range of up to 76 MHz, with tuning steps in increments of 100 kHz or 25 kHz for up to 3072 frequencies (19 MHz for block 941 version, for 695 frequencies). 

DSP compatibility modes are also included to work with legacy Lectrosonics analog wireless microphone receivers and IFB receivers, as well as some receivers from other manufacturers.

Key Features and Benefits

• Accepts microphone or line level signals
• Selectable 5, 15, 48 volt phantom power
• 76 MHz tuning range in 100 kHz or 25 kHz steps for up to 3072 frequencies (bands A1, B1, C1)
• 941 band offers 695 frequencies over 19 MHz tuning range with 25 kHz steps
• Selectable 50/100 mW output power
• Adjustable low frequency roll-off
• Powered by two AA batteries
• USB port for firmware updates
• IR (infrared) port for fast setup
• Solid machined aluminum housing

Included Accessories:
(2x) AA Alkaline Batteries
(1x) HM Pouch (Part #PHTRAN3)
(1x) Quickstart Guide

Specifications
Operating Frequency Range:
941.525 - 951.975 MHz
952.875 - 956.225 MHz
956.475 - 959.825 MHz

Frequency Selection Steps:
Selectable; 100 kHz or 25 kHz

RF Power output:
Selectable 50/100 mW

Pilot tone:
27 to 32 kHz; 3.5 kHz deviation (in the Digital Hybrid mode)

Frequency stability:
± 0.002%

Spurious radiation:
Compliant with ETSI EN 300 422-1 v1.4.2

Equivalent input noise:
–125 dBV (A-weighted)

Input level:
Nominal 2 mV to 300 mV, before limiting / Greater than 1V maximum, with limiting

Input impedance:
300 Ohms

Input limiter:
Dual envelope “soft” limiter; greater than 30 dB range

Gain control range:
55 dB; panel mounted membrane switches

Modulation indicators:
Dual bi-color LEDs indicate modulation of -20, -10, 0, +10 dB referenced to full modulation